1. wire
   Material: stainless
2. 2pcs wire gripping handles

A and B feed the wire through the hole in the wedge shaft. Loop it through the hole at the top of the shaft. Then back into the handle. Pressing the wedge back into the handle, the wires is held.

3. windshield removal tool
   Cuts the vinyl adhesive compound around windshield.

4. wire feeder tool
   Designed for easy and flexible insertion of wire through polyurethane,allowing speedy removal of bonded windshield. Allowing speedy removal of bonded windshield.
5. trim pad remover
   Place the tool under the edge of the door upholstery panel and insert it into the fastener as far as possible,then simple pry up,
6. windshield molding release tool
   Use for removal of windshield molding on rubberless installation.